|
|
|
|
|
This setup is off a mid 90's Toyota. I had done alot of research and was in the process of modifying it for use on Mom's 99 Explorer but, she passed away abruptly and I'm finally getting around to getting rid of it.
Yes it has surface rust from sitting in garage for a while. The yoke on the second image is just surface rust on a (then)new yoke, it all still spins supper smooth but, I'd just as soon replace it. Comes with the bracket and cable to disconnect from inside cab of vehicle.
Here's a link to see all about it:
http://www.remcotowing.com/drive_shaft.php
ASKING $300 OBO (Want it gone the sooner the better) Might be willing to ship it, would need time to figure it all out though. I think I paid close to $50 for shipping it back then? I would image that shipping now might be doubt due to fuel surcharges.
pictures at the remco link above for now. but can update with email pic's too... IF your patient (from my *crackberry* :>) phone).
|
|
|
